The introduction of the Dustbin Mould is as follows: A well-designed mold structure design is a prerequisite for a qualified mold manufacturing. The mold structure and product structure can be analyzed in all aspects (including: mold release angle, product surface microcosm, pouring System design, exhaust system design, cooling system design, etc.) The most important and most prone problems of these molds will be repeated trials during mold structure design. 2. Mold cooling system design The design of the cooling system is a relatively complicated task, that is, the cooling effect and uniformity of the cooling must be considered, and the influence of the cooling system on the overall structure of the mold must be considered. The specific location and size of the cooling system are determined; Key parts such as the cooling of moving molds or inserts; cooling of side sliders and side cores; design of cooling elements and selection of cooling standard elements. Our company began to analyze these series of problems during mold design. The mold uses circulating water to flow in every part of the mold to reduce the cooling time during injection molding, improve product production efficiency, and greatly reduce production costs. 3. Mold maintenance Mold maintenance is more important than mold repair. The more the mold is repaired, the shorter its lifespan. The better the mold is maintained, the longer its lifespan will be.
Same as Package Mould, mold maintenance is mainly divided into three points: 1. Daily maintenance of the mold: various moving parts such as ejector pins, rows, guide posts, guide sleeves, refueling, mold surface cleaning, and water drainage, which are maintained daily during mold production. 2. Regular maintenance: Regular maintenance includes the cleaning of the exhaust slot in addition to the daily maintenance, the air trapped and the black level and the exhaust, and the correction of damage and wear parts. 3. Appearance maintenance: paint the outside of the mold base to avoid rust. When the mold is lowered, the fixed mold and the movable mold should be coated with anti-rust oil. The mold should be closed tightly to prevent dust from entering the cavity. The information of the packaging mold is similar to the above description, please consult and contact us.